How To Propogate Lantana Camera

Wow. I've simply finished reading several online articles about propagating lantana and they are almost identical.

One gardening site author says to "Take cuttings of new growth in leap." She advocates taking stem cuttings of iv-inches, use rooting hormone and to stick the cutting in seed starting mix.

The entire offset folio of Google results all read similar a carbon copy of the above, erroneous data.

While post-obit this advice may yield a rooted cutting, your gamble of success is a lot less than if yous use hardwood basal cuttings stuck in sand.

Oh – and rooting hormone is not required to propagate lantana with hardwood cuttings.

What you need to root a lantana cutting

Sharp pruning shears or garden snips
Planting pot
Coarse sand (silica sand #12 or any size up to #eighteen)

Preparing the propagation container

Use any container you like to propagate the lantana cutting. Keep in mind, however, that aside from drainage holes, information technology should be able to adapt eight-inch (or longer) cuttings

The most challenging part of the lantana propagation process is finding the right sand. Your best bet is to purchase it from a gravel m in your area (Google "gravel" followed by the proper noun of your boondocks or metropolis.)

This is how nosotros get ours. But not all towns take a gravel k and the big box department stores (at least when I shopped there) didn't sell the advisable size sand.

Some other option is to get online and buy this i at Amazon.com. Pricier than what you'd pay at a gravel yard, this will definitely piece of work. If all else fails, apply peat moss.

Moisten the sand before pouring it into the container or you may terminate up losing a lot of it through the drainage holes. Pack the moist sand into the container.

Taking the lantana cut

For those new to establish propagation, information technology'southward important to know when to take a cutting. You'll have greater success, depending on the constitute, when the cutting is taken at the right time.

There are four chief types of plant cuttings: Softwood, hardwood, semi-hardwood and herbaceous.

Softwood cuttings are taken from immature stems that oft have foliage. Although these stems are somewhat flexible, they will pause if you bend them sharply. These are cuttings y'all'll take early in the growing season and ofttimes yous'll want tip cuttings.

Hardwood cuttings, on the other hand, are typically taken when a constitute is dormant (later the leaves have dropped) and from woody stems.

Then there are semi-hardwood and herbaceous cuttings, which nosotros'll discuss some other day.

What nosotros demand to propagate lantana is a basal hardwood cutting. And now, in wintertime, is the all-time time to take the cutting.

Select mature, woody stems from concluding season'due south growth. Cut the stems from as close to the crown as possible and try to get at least 7.five inches.

If the stem has foliage, remove information technology. Then, use sharp snips to make a cutting at the top of the stalk, just above a node (never keep the terminal bud when propagating lantana with this method). And so, cut the bottom of the stalk diagonally, just below the basal bud (the everyman node on the stem. See the diagram, to a higher place).

Stick the cutting, diagonally-cut finish down, into the sand, ensuring that at to the lowest degree 2 nodes are buried. Use your hands to pack the sand around the cut to ensure there'south proficient contact. And then, water it (this, too, will settle the sand around the cutting and remove air pockets).

Practice not cover the potted cutting with a plastic pocketbook, as some gardening sites recommend. The acme of the cutting must remain cool (higher up freezing, though) and dry.

Find a spot where the cut volition go lots of natural sunlight and cheque information technology daily to ensure that the sand remains moist.

The cutting should root within four to five weeks.